Px-W4220Ti Internal Drive - Rear Panel - Plextor PX-W4220Te Operation Manual

CHAPTER 5 — Drive Features
Write H Indicator: Orange when recording CD-R discs at 4X speeds. Also
on (simultaneously with Write L Indicator) when recording CD-RW discs at
2X speed.
CD-Audio Play Button: With audio CD in drive, push once to put drive in
CD-Audio play mode. Push button once during CD play mode to skip
tracks. Push and hold down play button more than one second to fast
forward.
Stop/Eject Button: Push to eject tray. During CD-DA play mode, playback
is stopped when pressed once, and the disc ejects when pressed twice.
Emergency Eject Hole: Insert emergency eject stick, paper clip, or other
thin, rigid object to eject tray if automatic eject button does not work. Turn
OFF power before using this feature.
Rear Panel — PX-W4220Ti Internal Drive
Audio Output
Connector
Audio Output Connector: Outputs stereo analog signal. Use to connect to
sound board or audio amplifier. Use standard MPC-3 type, 4-pin connector.
Jumpers: Use to select SCSI ID number, parity, termination, or block size.
Leave these jumpers at their factory settings unless one or more of the
following situations pertain to you:
SCSI ID number: If you are using more than one SCSI peripheral, you
may have to change your SCSI ID number; see page 14.
Termination: Review Chapter 7 to determine if you need to turn your
terminator switch off.
Block size: If you are working in a UNIX environment and want to boot
from your CD-RW drive, see page 17.
SCSI Interface Connector: Connects to SCSI interface board using 50-pin
to 50-pin flat ribbon SCSI cable.
Power Connector: Connects to your computer's power supply (DC +5V and
+12V).
10
PX-RW 4/2/20 OPERATION MANUAL
Jumpers
SCSI Interface Connector Power Connector