Rear Panel-Internal Drive - Plextor PX-W8220Te Operation Manual

Section 1. Getting Started
WRITE H indicator: Orange when recording CD-R discs at 8X speed.
Both WRITE H and WRITE L indicators are turned on (orange) when recording
CD-RW discs at 2X speed.
CD-Audio play/skip forward button: With an audio CD in the drive, push once
to put the drive in CD-Audio play mode. Push button once during CD play mode
to skip tracks. Push and hold down this button more than one second to fast
forward.
Stop/Eject button: Push to eject tray. During CD play mode, press once to stop
playback; press twice to eject the disc.
Emergency eject hole: Insert emergency eject stick, paper clip, or other thin,
rigid object to eject tray if automatic eject button does not work. Turn OFF power
before using this feature.
Rear Panel—Internal Drive
Figure 2: Rear Panel of the PlexWriter 8/2/20 Internal Drive
Audio output connector: Outputs stereo analog signal. Use to connect to sound
board or audio amplifier. Use standard MPC-3 type, 4-pin connector.
Jumpers: Use to select SCSI ID, parity, SCSI termination, or block size. Leave
these jumpers at their factory settings unless one or more of the following
situations pertains to you:
SCSI ID: If you are using more than one SCSI peripheral, you may have to
!
change your SCSI ID number; see page 16 for details.
PRTY: Parity. In some cases, you may need to turn parity off; see page 15.
!
TERM: SCSI termination. In some situations, you may need to set this
!
jumper to turn the PlexWriter's SCSI termination off; see page 17 for details.
6
PlexWriter 8/2/20 Operation Manual