Set The Drive's Mode Jumper; Changing The Mode Jumper On Your Internal Plexwriter Drive - Plextor PX-W5224TA Installation And User Manual

Atapi cd-r/cd-rw drive
Table of Contents

Advertisement

Section 2. Installing Your PlexWriter

Set the Drive's Mode Jumper

You specify your drive's Master or Slave setting before installing it. You do this by
changing the position of a jumper on the mode jumper block at the rear of the drive.
Your drive ships from our factory with its mode jumper set to operate the PlexWriter
as a Master. This will work in most custom system configurations. If your computer
is from a large OEM system manufacturer such as IBM, Hewlett Packard, Gateway
or Compaq, you will need to pay particular attention to whether the computer uses
the Cable Select scheme.
Changing the Mode Jumper on Your Internal PlexWriter
Drive
The PlexWriter drive arrives from the factory with its mode jumper set to Master. (A
function is ON if the jumper is installed and OFF if the jumper is removed.)
Figure 4: Factory Settings for Mode Jumper at the Rear of the Drive
11
PlexWriter 52/24/52A Installation and Users Manual

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Plexwriter 52/24/52a

Table of Contents