Px-32Xse (External Drive); Rear Panel (Caddy, Tray) - Plextor UltraPlex PX-32CSe User Manual

PX-32XSe External Drive (Caddy, Tray)----REAR PANEL
SCSI Interface Connector
In and Out
DIP Switches: Use to set parity, term, test, block size, and eject lock options.
Leave these switches at their factory settings unless one of the following pertain
to you:
Termination: Review Chapter 7 to determine if you need to turn your terminator
switch off.
Block Size: If you are working in a UNIX environment and want to boot from your
CD-ROM drive, see page 18.
Eject Lock: If you work in an environment where you need to prevent others from
removing a CD-ROM disc from your drive, see page 18.
SCSI ID: Use this dial to designate SCSI ID number. Rotate the dial to change the
number. If you are using more than one SCSI peripheral, you may need to change
your SCSI ID number (see pages 16 and 17).
Power Switch: To turn power ON/OFF.
AC Power Input: Use the power cord supplied with your drive.
Audio Output: Outputs stereo analog signal via RCA jacks. Use to connect to
audio amplifier or other audio equipment.
SCSI Interface Connector In and Out: One connector should be used to link
your CD-ROM drive to your SCSI host adapter; the other to link your CD-ROM drive
to another SCSI peripheral with a daisy chain cable (see page 32). You may use either
connector for either purpose.
CHAPTER 5 ---- Drive Features
Power Switch
SCSI ID
DIP Switches
Audio Output
AC Power Input
(RCA jacks)
ULTRAPLEX OPERATION MANUAL
13