Pairing The Rugby 640 With The Rc400 Remote Control - Leica Rugby 640 User Manual

Applications
2.5.1
Pairing step-by-step
Rugby 640, Description of the System
• For layout work use the Beam down feature to position the beam over a reference
point. Then use the Scan 90° feature to quickly move the small scan to a position
to the left or right of the laser.
• For ceiling applications and marking elevations the Scan 90° feature can quickly
bring the scanning beam to you.

Pairing the Rugby 640 with the RC400 Remote Control

The Rugby 640 and the RC400 Remote Control include radio devices that allow the
user to activate additional functions on the Rugby.
When purchased together, the Rugby 640 and the RC400 have been paired together
at the factory. Should it be necessary to pair your units after purchase, the following
information is applicable.
Before using the RF features, the Rugby and the Remote Control must first be paired
together to be able to communicate with each other.
Step Description
1. Turn off the Rugby 640.
2. Press and hold the Power button on the Rugby 640 for 5 seconds to turn on
the Rugby 640 in pairing mode. The Rugby 640 beeps five times.
3. Press and hold the Head Speed button and the Scan Mode button on the
RC400.

The X-axis Indicator LED and the Y-axis Indicator LED flash green and the
Rugby 640 beeps five times quickly when the pairing was successful.
The X-axis Indicator LED and the Y-axis Indicator LED flash red five times
quickly if the pairing was not successful.
18