Table of Contents
Advertisement
Changing the Li-Ion
batteries step-by-
step
Rugby 640, Batteries
Step
Description
3.
Connect the charger plug into the charge jack on the Rugby battery pack.
4.
The small LED next to the charge jack flashes indicating that the Rugby is
charging. The LED is on solid when the battery pack is fully charged.
5.
When the battery pack is fully charged, disconnect the charger plug from the
charge jack.
6.
Slide the locking mechanism to the centre position to prevent dirt from
getting into the charging jack.
The battery pack reaches a full charge in approximately 5 hours if completely
empty. A one hour charge should allow the Rugby to run for a full eight hours.
The Low Battery Indicator LED on the Rugby flashes when the batteries are low and
need to be charged.
The charge indicator LED on the Lithium-Ion battery pack indicates when the pack is
being charged (flashing slowly) or fully charged (on, not flashing).
005825_001
Step
Description
The batteries are inserted in the front of the laser.
The rechargeable battery pack can be recharged without being removed
from the laser. Refer to "Charging the Li-Ion battery pack step-by-step" for
further information.
1.
Slide the locking mechanism on the battery compartment to the right and
open the cover of the battery compartment.
2.
To remove the batteries:
Remove the batteries from the battery compartment.
To insert the batteries:
Insert the batteries into the battery compartment.
3.
Close the cover of the battery compartment and slide the locking mecha-
nism to the left centre position until it locks into position.
2
1
3
37
Advertisement
Table of Contents
