Table of Contents
Advertisement
Setup
5.8
More applications
Rugby 640, Applications
Step
Description
3.
In the laying down position the Rugby will move the beam to downwards for
alignment over your reference.
4.
Start the head rotation or scanning motion to roughly align the beam to a
second control point.
5.
Using the buttons on the laser or the remote control, fine adjust the beam
until striking the second control point.
6.
Once aligned the split beam and rotating beams can be used to locate 90°
angles for layout. The rotating beam also creates a vertical plane for trans-
ferring points from the floor to the ceiling.
When using the Rugby in the laydown position use the
left or right arrow buttons on your remote control to
quickly align the vertical plane or plumb beam to the
second reference point. (1).
The scanning beam can be moved quickly to the left or
right side of the laser using the Scan 90° button (2).
To check the alignment over a point press the Beam
down button (3).
More Applications
Exterior Applications
• Setting elevation of forms and footings
• Squaring of forms
• Checking elevations and benchmarks
• Landscaping
• Drainage and septic systems
• Fences and retaining walls
• Decks and patios
• Simple driveways or small parking lots
• Facade Installations
• Batter board setups
Interior Applications
• Suspended ceilings
• Walls and partitions
• Vertical alignment
• Transferring points from floor to ceiling
• Vertical plumb
• Layout of floors
• Squaring of angles
• Setting cabinets
• Chair rails and wainscoting
• Alignment of wall and floor tiles
• Trim carpentry
• Setting sprinkler head heights
• Sloped ceilings
1
1
2
3
004814_001
35
Advertisement
Table of Contents
