Table of Contents
Advertisement
Setup
5.7
Description
Layout
Rugby 640, Applications
Step
Description
1.
After mounting the first strip of ceiling trim at the desired height (centre
position of the ceiling target) below, attach the wall mount bracket and laser
to the trim. Tighten the locking knobs on the top of the bracket.
2.
Press the Power button to turn on the Rugby and allow the Rugby to self-
level.
3.
Adjust the Rugby so that the rotating beam is at the desired height below
the ceiling grid. Loosen the adjustment knob on the side of the bracket and
slide the Rugby up or down. When at the desired height, retighten the
adjustment knob.
4.
Install the ceiling grid using the ceiling grid target and laser beam as your
reference.
When installing suspended ceilings use the remote
control to change to scanning mode for increased visi-
bility (1).
The scanning beam can be rotated using the clockwise
and counter clockwise buttons on the remote (2).
The scanning beam can be moved quickly in 90° incre-
ments using the Scan 90° button (3).
Layout
In the laying down position the Rugby 640 can be used for laying out wall positions,
squaring, transferring points and more.
The Rugby 640 projects two laser beams at a 90° angle to each other.
005823_001
Step
Description
1.
Place the Rugby in the laydown position.
2.
Press the power button to turn on the Rugby.
The Rugby will always turn on in Automatic Mode. Allow the Rugby to self-
level.
5
4
1
2
3
004812_001
2
1
3
34
Advertisement
Table of Contents
