Operating Modes; Automatic And Manual Modes - Samson 3730 Series Mounting And Operating Instructions

Press to access the selected code. The
code number starts to blink.
Turn and select the setting.
Press to confirm the selected setting.
Note: If no settings are entered within 120
seconds, the enabled configuration function
becomes invalid and the display changes to
Code 0.
Cancel the setting:
To cancel a value before it is confirmed (by
pressing ) proceed as follows:
Turn
→ ESC
Press . The entered value is not adopted.
Canceling the setting
8.2

Operating modes

8.2.1 Automatic and manual
modes
After initialization has been completed suc-
cessfully, the positioner is in
mode (AUTO).
%
Switch to manual operating mode
(MAN)
Turn → Code 0
Press , display: AUtO,
Code 0 blinks.
Turn → MAN
Press to switchover to
The switchover is smooth since the manual
mode starts up with the set point last used
during automatic mode. The current position
is displayed in %.
Operation
automatic
Automatic mode
manual mode.
EB 8384-4 EN
71