Operating Modes; Automatic And Manual Modes - Samson 3730-4 Mounting And Operating Instructions

Operating the positioner
Turn until Code 3 appears (reading: No).
Press , the code number 3 blinks.
Change the setting in Code 3.
Turn until YES appears.
Press , reading:
Configuration is enabled.
You can now configure codes one after the
other:
Turn to select the required code.
Press to activate the selected code. The
code number starts to blink.
Turn to select the setting.
Press to confirm the selected setting.
If no settings are entered within 120 seconds, the enabled configuration function becomes in-
valid and the display returns to Code 0.
Cancel the setting:
To cancel a value before it is confirmed (by pressing
Turn until ESC appears.
Press to confirm.
The entered value is not adopted.

7.13 Operating modes

7.13.1 Automatic and manual modes

After initialization has been completed suc-
cessfully, the positioner is in
(AUTO).
114
automatic mode
Code 3
Configuration not
enabled
Configuration enabled
) proceed as follows:
Canceling the reading
Automatic mode
%
EB 8384-4 EN