Service Safety Summary - Tektronix AWG2005 Service Manual

Do Not Service Alone
Disconnect Power
Use Caution When
Servicing the CRT
Use Care When
Servicing With Power
X Radiation
AWG2005 Service Manual
Only qualified personnel should perform service procedures. Read this Service
Safety Summary and the General Safety Summary before performing any service
procedures.
Do not perform internal service or adjustments of this product unless another
person capable of rendering first aid and resuscitation is present.
To avoid electric shock, disconnect the main power by means of the power
cord or, if provided, the power switch.
To avoid electric shock or injury, use extreme caution when handling the CRT.
Only qualified personnel familiar with CRT servicing procedures and precau
tions should remove or install the CRT.
CRTs retain hazardous voltages for long periods of time after power is turned
off. Before attempting any servicing, discharge the CRT by shorting the anode
to chassis ground. When discharging the CRT, connect the discharge path to
ground and then the anode. Rough handling may cause the CRT to implode.
Do not nick or scratch the glass or subject it to undue pressure when removing
or installing it. When handling the CRT, wear safety goggles and heavy gloves
for protection.
Dangerous voltages or currents may exist in this product. Disconnect power,
remove battery (if applicable), and disconnect test leads before removing
On protective panels, soldering, or replacing components.
To avoid electric shock, do not touch exposed connections.
To avoid x radiation exposure, do not modify or otherwise alter the high voltage
circuitry or the CRT enclosure. X ray emissions generated within this product
have been sufficiently shielded.

Service Safety Summary

xvii