Emi Gaskets; Front Cover, Trim Ring, And Menu Buttons - Tektronix AWG2005 Service Manual

Removal and Installation Procedures
6 22

EMI Gaskets

1. Remove front cover and trim ring: Do the Front Cover, Trim Ring, and
Menu Buttons procedure on page 6 22, removing only the front cover
and trim ring.
When reinstalling the EMI gaskets and/or the AWG2005 cabinet
carefully follow the instructions given to prevent exceeding the
environmental characteristics for EMI.
2. Remove EMI gaskets:
a. You will need needle nose pliers to do this part of the procedure.
b. Locate the EMI gaskets in the locator diagram, External Modules, in
Figure 6 3.
c. Use a pair of needle nose pliers to remove the four sections of EMI
gaskets from the groove in the trim ring.
3. Reinstall EMI gaskets: Press the EMI gaskets back into the groove in the
trim ring.

Front Cover, Trim Ring, and Menu Buttons

1. Assemble equipment and locate modules to be removed: No tools are
needed. Locate the modules to be removed in the locator diagram,
External Modules, in Figure 6 3.
2. Orient instrument: Set the AWG2005 with the back down on the work
surface and bottom facing you (see Figure 6 8).
3. Remove front cover: If the optional front cover is installed, grasp the front
cover by the left and right edges and snap it off of the trim ring. (When
reinstalling, align and snap back on.)
4. Remove front panel knob: Do the Front panel Knob procedure, on
page 6 17.
CAUTION
Maintenance