Cisco IE 1000 Hardware Installation Manual page 34

Running Express Setup
c. Typically, connectivity between the computer and the switch is lost because the configured switch IP address is
in a different subnet from the IP address on the computer.
d. If you changed the Management Interface Vlan ID, then after pressing submit, all Ethernet interfaces on the
IE 1000 are now members of this new vlan. This is to enable the connection to the network.
14. Remove the PC and connect the switch to the network as configured in step 12.
Note: After power cycling, the IE 1000 will not act as DHCP server. DHCP Server behavior is special to Express Setup.
to reconnect to the IE 1000 after the power cycle you will need to A) configure a static IP Address on your PC that is in
the same subnet as the IP Address you just assigned, or B) connect to the new IP Address of the IE 1000 from the
network.
I
15. You can now manage the switch by using the Device Manager. See the "Managing the Switch" section on page 9
for information about configuring and managing the switch.
You can display Device Manager by following these steps:
a. Start a web browser on your computer.
b. Enter the switch IP address, username, and password in the web browser, and press Enter. The Device
Manager page appears.
Troubleshooting:
If the Device Manager page does not appear:
— Ping the IP address of device from PC where browser is getting launched. If not check Computer's network
connectivity.
— Confirm that the port LED for the switch port connected to your network is green.
30