Display And Buttons; Figure 8 Solid-510 Display And Buttons - idp SOLID-510S User Manual

1.4 Display and Buttons

Control panel of Printer consists of 2 lines LCD and 2 buttons. The 2 buttons have the functions
as shown in the Figure 8.
Left
Button
The status of SOLID-510 is 'Initializing' when boot up. It is changed to 'System Ready' if the
printer is fine. It is change to 'Printing' when the printer is working. In case of sensing an error,
it is changed to 'Error' status. Whenever the top cover is opened, the operation is stopped and
the status is 'Top Cover Open'.
The functions of the button under each status are as below table.
Status
Initializing
System Ready
Printing
Error
Top Cover Open
Two Line LCD

Figure 8 SOLID-510 Display and Buttons

Left Button
N/A
Ribbon Type/Balance
Laminating Film Type/ Balance
User Printed Counts
Do Test Print
Network IP Address
Subnet
Gateway
Network MAC Address
Pulling out the card
N/A
Retry
Move to backward a card
Cleaning Mode (when both buttons are pushed)
16
Right Button
N/A
Sleep (Hold on 5 seconds)
Initializing (When Sleep Mode)
Ok
N/A
Cancel
Move to forward a card
Right
Button