idp SOLID-510S User Manual page 48

SBS Only: Please enable it when you issue cards with software programed by SDK.
This option disables printer device driver.
Safe Head Heat: Set not to print if the print head is overheated.
Cleaning Warning: Set to show the 'Do cleaning' message periodically
Use USB Serial: When SOLID-510 is connected to USB, it transmits the USB serial
number to PC. Default is the same number used by all SOLID-510. Please set this
option when you use multiple SOLID-510 printers connected to 1 PC via USB. It
enables unique serial numbers for each USB.
Mag. Head Position: SOLID-510 can install the magnetic encoder on upper/lower side
of a card. You can set it depending on the position of encoder.
Card Out: Set the way to eject cards.
Error Card Out: Set the way to eject error cards.
Auto Front Card In: Set to input a card automatically if the front card-in sensor
detects a card. It is used for the KIOSK model.
Auto Rear Card In: Set to input a card automatically if the rear card-in sensor detects
a card. It is used for the KIOSK model.
Dump Mode: It records log data to inspect the operation of printer.
User Mag. Current: The default current value when the user selects to use the
defined value when magnetic encoding
Mag. Write Mode: You can order the way how to encode magnetic stripe.
"L:A, H:I": encodes 3 tracks at once for LoCo card and encodes at twice by dividing 1,3
and 2 track for HiCo card.
Magnetic Start Position: Set the start position of magnetic stripe when you encode.
Card In Speed: set the speed of inputting a card
Card Move Speed: set the speed of moving a card
Card Eject Speed: set the speed of ejecting a card
48