Setting Allocation Class - DEC VAX 4000 300 Manual

In Example B–3,
SET HOST/DUP/DSSI/BUS:1 0 PARAMS
DUP server for the ISE at node 0 of embedded DSSI bus 1. In Example B–4,
SET HOST/DUP/UQSSP/DISK 0 PARAMS
the ISE at controller 0 of a KFQSA-based DSSI bus.
Example B–3: Starting the DUP Driver Utility (Embedded DSSI)
>>>SET HOST/DUP/DSSI/BUS:1 0 PARAMS
Starting DUP server...
Copyright (c) 1991
PARAMS>
Example B–4: Starting the DUP Driver Utility (KFQSA-Based DSSI)
>>>SET HOST/DUP/UQSSP/DISK 0 PARAMS
Starting DUP server...
Copyright (c) 1991
PARAMS>
B.3.2 Setting Allocation Class
After entering the DUP driver utility for a specified device, you can examine
and set the allocation class for the device as follows:
1. At the prompt, enter
PARAMS>
class of the ISE to which you are currently connected.
2. Enter
SET ALLCLASS 2
3. Enter
SHOW ALLCLASS
is entered to start the DUP server for
Digital Equipment Corporation
Digital Equipment Corporation
SHOW ALLCLASS
(or enter the allocation class you desire).
to verify the new allocation class.
Programming Parameters for DSSI Devices
is entered to start the
to check the allocation
B–9