Table of Contents
Advertisement
Figure B–2 shows sample DSSI busses and bus node IDs for an expanded
VAX 4000 Model 300 system.
NOTE: Your system need not have the maximum number of devices, as do
the examples in this appendix.
Figure B–2: Sample DSSI Busses for an Expanded VAX 4000 Model 300
System
System
3 2 1 0
Bus 0
Bus 1
1. Enter the console mode.
The procedure for programming parameters for DSSI devices from
console mode requires that you issue commands to those devices at
the console prompt (>>>). You may enter these commands in either
uppercase or lowercase letters. Unless otherwise instructed, enter each
command, then press Return.
Enter console mode as follows:
a. Set the Break Enable/Disable switch on the system console module
to the enable position (up, position 1).
Expander
3 2 1 0
6 5 4
DSSI Cable
Programming Parameters for DSSI Devices
MLO-006546
B–5
Advertisement
Table of Contents
