DEC VAX 4000 300 Manual page 101

b. Set the Power switch for each unit (both hosts for a dual-host
system, and any expanders for expanded systems) to on (1).
Wait for the system to display the console prompt (
2. To display the DSSI devices on embedded DSSI busses, enter
at the console prompt. To display the DSSI devices on KFQSA-based
DSSI busses, enter
The firmware displays two lines of information for each device. For
embedded DSSI, the firmware displays the following:
• The first line contains the bus number, node number, and node
name.
• The second line contains the device name and unit number followed
by the device type in parentheses.
For embedded DSSI, the device name consists of the letters DIAu or
DIBu (MIAu or MIBu for the TF85 tape drive)—devices on bus 0 are
listed as DIA, devices on bus 1 are listed as DIB—and u is a unique unit
number. The embedded DSSI host adapter for each bus is identified by
an asterisk (*).
The embedded DSSI display for Example B–1 shows a system with four
DSSI devices (unit numbers 0–3) and an R400X expander with seven
DSSI devices (unit numbers 0–6).
B–6 VAX 4000 Model 300 Operation
.
SHOW UQSSP
).
>>>
SHOW DSSI