Installing The Server Into A Telco Rack - Supermicro AS-1013S-MTR User Manual

Installing the Server into a Telco Rack

To install the AS -1013S-MTR into a Telco type rack, use two L-shaped brackets on either
side of the chassis (four total).
1. First, determine how far the server will extend out the front of the rack. Larger chassis
should be positioned to balance the weight between front and back. If a bezel is
included on your server, remove it.
2. Then attach the two front brackets to each side of the chassis, then the two rear
brackets positioned with just enough space to accommodate the width of the rack.
3. Finish by sliding the chassis into the rack and tightening the brackets to the rack.
Figure 2-3. Installing the Server into a Telco Rack
Note: Figure is for illustrative purposes only. Always install servers to the bottom of a rack first.
Chapter 2: Server Installation
22