Supermicro AS-1013S-MTR User Manual page 27

A+ Server AS -1013S-MTR User's Manual
5. The CPU package is shipped from the factory with the blue carrier frame pre-assembled.
Grip the handle of the carrier frame/CPU package assembly from its shipping tray, and
while gripping the handle, align the flanges of the carrier frame onto the rails of the rail
frame so its pins will be at the bottom when the rail frame is lowered later.
6. Slide the carrier frame/CPU package downwards to the bottom of the rail frame. Ensure
the flanges are secure on the rails as you lower it downwards.
Note: You can only install the CPU inside the socket in one direction with the handle at the
top. Make sure that it is properly inserted into the CPU socket before closing the rail frame
plate. If it doesn't close properly, do not force it as it may damage your CPU. Instead, open
the rail frame plate again, and double-check that the CPU is aligned properly.
7. Lift up the rail frame till it securely rests in upright position. Then remove the PnP cover
cap from the CPU socket below. Grip the two lift tabs marked "Remove" at the middle of
the cap and pull vertically upwards to remove the PnP cover cap.
Warning! The exposed socket contacts are extremely vulnerable and can be damaged easily.
Do not touch or drop objects onto the contacts and be careful removing the PnP cover cap and
when placing the rail frame over the socket.
8. Gently lower the rail frame down onto the socket until the latches on the rail frame
engage with the socket housing and it rests in place. DO NOT force it into place!
Carrier Frame/
CPU Package
27