Table of Contents
Advertisement
The following image illustrates the IrDA communication USB dongle connected to ERX350.
5.3.4 Signing on to the ERX350
Open MasterLinkR515 & MasterLinkSQL and fill in any fields in the opening screen. You can connect to a
specific site through the Site List (this is required for remote connections through a modem), or, for local
connections you can simply request some operation and MasterLinkR515 & MasterLinkSQL will initiate
the connection automatically.
If requested, enter a user ID and passcode. Your organization should provide you with this information.
User ID can be any value from 0 to 99. By default, only users 0 through 3 are activated. Passcode can be
any value 0 to 99999. Given below are the default passcodes for users 0 to 3.
User
Default Passcode
User 0 and 1 33333
User 2
20000
User 3
30000
Default users 2 and 3 are primarily intended for HMI access (levels 2 and 3 respectively) but serial
access with MasterLinkR515 & MasterLinkSQL through those users is also possible with those
passcodes.
Updating ERX350 Firmware
ERX350 is provided with a built-in firmware loader that allows new versions of firmware to be installed
easily. Firmware can be upgraded using the Firmware Upgrader option available in the MasterLinkR515
& MasterLinkSQL software. When you select this option, the MasterLinkR515 & MasterLinkSQL software
works with the built-in loader of ERX350 and provides a very robust system for upgrading the ERX350
firmware.
Honeywell
2023
5.3 Connecting to ERX350 via MasterLinkR515 & MasterLinkSQL
5 User Access
112
Advertisement
Table of Contents
