Maintenance - ElectrIQ iQool9PLUS-V2 User And Installation Manual

FILTERS
Ensure the power is turned off to the unit before attempting to service the filters.
REMOVING AND REPLACING THE FILTERS
1. Hold the front panel open (or put it in horizontal
position) and remove the filter(s).
2. Use a vacuum cleaner to remove dirt. If the dust
filter is very dirty, it may be washed in lukewarm
water with a very small amount of neutral detergent.
Rinse well and allow to dry completely (not in direct
sunlight or near a source of heat).
INDOOR UNIT: While the unit is disconnected from power dust regularly with a dry cloth or
slightly damp paper towel. Never use chemicals or solvents. Never spray a liquid in or over the
appliance.
OUTDOOR UNIT: While the unit is disconnected from power. Remove dirt and keep the air
intake and exhaust openings free of debris, etc. Cleaning with chemicals may cause damage.

MAINTENANCE

OPENING THE FRONT PANEL: At the recesses,
pull the front part up with both hands. The front
panel will stay horizontal (at around 90°).
CLOSING THE FRONT PANEL: Press the front
part down at the sides and in the middle. Make
sure it is properly clicks into place.
3.
4.
24
Keep the front panel open and
reinstall the filter(s). Press the panel
shut; a click indicates it is closed
properly.
Restore the power from the
consumer unit and turn the air
conditioner on.