Table of Contents
Advertisement
4.2
Communication Modules
Overview
4.2.1
SIPROTEC devices can be ordered with factory-installed communication modules. The communication modules
can also be installed and replaced in the SIPROTEC devices afterwards. You do not have to open the device for
this.
NOTE
i
i
The communication modules available for reordering are not preconfigured. Use DIGSI 5 to carry out the
functional adjustment to the required protocol application.
The communication modules can be installed in the base module or the 1/3 module and in the expansion
module with the plug-in module assembly CB202. A maximum of 2 communication modules each can be
installed. You can use only one CB202 in the device.
The plug-in module assembly CB202 is a printed circuit board assembly with an integrated power supply.
The plug-in module assembly CB202 communicates with the base module via a special connecting cable. This
connecting cable (CAT 5 FTP patch cable) is always included in the scope of delivery of the plug-in module
assembly CB202 or the devices containing the plug-in module assembly CB202 and needs not be ordered
separately.
Ensure that you route the communication lines separately from network circuits.
[le_cm201p, 1, --_--]
Figure 4-1
SIPROTEC 5, Hardware Description, Manual
C53000-G5040-C002-J, Edition 08.2020
Plug-In Module Positions and Communication Terminals in the Base Module, with Modular
Devices
Plug-In Modules
4.2 Communication Modules
153
Advertisement
Table of Contents
