Table of Contents
Advertisement
1. Adjust the number of days with
2. Press
to validate the selection and advance to the next
parameter.
ð Can be adjusted from:
1 to 99 days for timeclock regeneration;
OFF to 99 days for metered regeneration.
6.1.5.17 Regeneration time
Set the time for regeneration start.
Mandatory
Must be set when the valve is in timeclock or meter delayed mode or with a calendar
override !
1. Adjust the time of regeneration with
2. Press
to validate the selection and advance to the next
parameter.
6.1.5.18 Cycle times
Set the cycle times of the regeneration.
Info
Five cycles can be set.
The system displays the programming cycles and allows setting of a specific time for
each cycle. If a cycle is set to NO, the next cycles is not activated.
The sequence of the regeneration cycles depends upon regenerant flow, see System
regeneration cycle [
Ref. MKT-IM-010 / F - 16.01.2023
,
and
,
→
Page 26].
Installer manual Fleck 3150 NXT/NXT2 - Programming
.
Without calendar forcing.
Forcing every 3 days.
and
.
Regeneration at 2:00 am
(default).
83 / 190
Advertisement
Table of Contents
