Table of Contents
Advertisement
No.
Item
(1)
[DHCP]
Default: OFF
ON
OFF
(2)
[IP address]
Default: 192.168.0.10
(3)
[Net mask]
Default: 255.255.255.0
(4)
[Default gateway]
Default: 192.168.0.1
(5)
[HTTP port]
Default: 80
(6)
[DNS]
Default: MANUAL
AUTO
MANUAL
(7)
[Primary DNS]
[Secondary DNS]
(8)
[Line speed]
Default: AUTO
AUTO
100M-FULL
100M-HALF
10M-FULL
10M-HALF
Select whether or not to use the DHCP function.
Configure the DHCP server not to assign the same IP address for the
PCs (ones not using DHCP function) and other network cameras.
The DHCP function is used.
The DHCP function is not used.
When the DHCP function is not used, enter the IP address of the camera.
Do not enter an IP address already in use (for the PCs and the other
network cameras).
When the DHCP function is not used, enter the subnet mask of the
camera.
When the DHCP function is not used, enter the default gateway address
of the camera.
Assign HTTP port numbers independently.
Available port number: 1 to 65535
................................................................................................................
Note
• Use any port numbers other than the following as the HTTP port
number: 20, 21, 23, 25, 42, 53, 67, 68, 69, 110, 123, 161, 162, 995,
10669, 10670.
.....................................................................................................................
Select whether to obtain DNS server address manually or automatically.
When using the DHCP function, it is possible to obtain the DNS server
address automatically by selecting "AUTO".
Enter DNS server address when DHCP function is no in use. It is
necessary to enter "Primary DNS" and "Secondary DNS". (These
settings can also be entered when using the DHCP function.)
When "MANUAL" is selected for [DNS], enter the IP address of the DNS
server.
Select the line speed for transmission.
................................................................................................................
Note
• Normally, we recommend using the default, "AUTO".
.....................................................................................................................
The line speed will be automatically selected.
100 Mbps full-duplex is selected as the line speed for transmission.
100 Mbps half-duplex is selected as the line speed for transmission.
10 Mbps full-duplex is selected as the line speed for transmission.
10 Mbps half-duplex is selected as the line speed for transmission.
53
Description
(1/2)
Advertisement
Table of Contents
