Table of Contents
Advertisement
Setting the NTP server [NTP]
Click the [NTP] tab on the "Basic setup" page.
Settings relating to the NTP server, such as NTP server address and port number, can be configured on this
page.
(1)
(2)
(3)
(4)
(5)
No.
Item
(1)
[Time adjustment]
Default: Manual setup
Manual setup
Synchronization
with NTP server
(2)
[NTP server address]*
Default: None (blank)
(3)
[NTP port]*
Default: 123
(4)
[Synchronization
interval]*
Default: 1 hour
(5)
[Time zone]*
Default: (GMT)
Greenwich Mean Time :
Dublin, Edinburgh,
Lisbon, London
*
Set these items when [Time adjustment] is set to "Synchronization with NTP server".
Select whether time should be adjusted manually or synchronized with
the NTP server.
The time set on the [Basic] tab on the "Basic setup" page will be used as
the standard time of the camera.
The time automatically adjusted by synchronizing with the NTP server will
be used as the standard time of the camera.
Enter the IP address or host name of the NTP server.
Number of characters for the NTP server address: 1 to 128
Important
• When entering the host name for [NTP server address], it is
necessary to configure the DNS settings on the [Network] tab of the
"Network setup" page. (→ page 52)
• Enter the domain name using alphanumeric characters.
Enter a port number to be used for the NTP server.
Available port number: 1 to 65535
Select an interval (1 - 24 hours: in 1 hour intervals) of synchronization
with the NTP server.
Select a time zone corresponding to the location where the camera is in
use.
12
Description
Advertisement
Table of Contents
