Table of Contents
Advertisement
Setting host authentication [Host]
Click the [Host] tab on the "Authentication setup" page.
The settings relating to host authentication for restricting the PC (IP address) that accesses the camera can
be configured on this page.
(1)
(2)
(3)
(4)
No.
Item
(1)
[Host authentication]
Default: OFF
ON
OFF
(2)
[IP address]
(3)
[Access level]
Default: 3 Live only
1. Administrator
2. Camera control
3. Live only
Select whether or not to authenticate the host.
Important
• Before configuring host authentication, it is necessary to register the
IP addresses of the PCs to be allowed to access the camera and
determine their access levels. If "ON" is selected for [Host
authentication] before registering IP addresses, it will be impossible
to access the camera.
Hosts are authenticated.
Hosts are not authenticated.
Enter the IP address of the PC to be allowed to access the camera.
PCs cannot be designated by entering a host name.
................................................................................................................
Note
• When "IP address/subnet mask" is entered, it is possible to restrict
PCs in each subnet.
For example, when [192.168.0.1/24] is entered, and [2. Camera
control] is selected for [Access level], the PCs whose IP address is
between 192.168.0.0. to 192.168.0.255 can access the camera with
the access level [2. Camera control].
• When an IP already in use is entered and the [SET] button is clicked,
the respective host information will be overwritten.
.....................................................................................................................
Set the access level of the host.
For further information about the access level, see page 46.
The host is allowed use of all available camera functions and operations.
The host is allowed to display images and operate the camera.
The host is allowed only to display images.
48
Description
(1/2)
Advertisement
Table of Contents
