Advertisement
Installation (Cont.)
Final stage
ind insulating covering around
• W
the joints of the indoor unit and
fix it with insulating tape
(Fig. 21).
• Fix the exceeding part of the
signal cable to the piping or to
the outdoor unit.
• Fix the piping to the wall (after
having coated it with insulating
tape) using clamps, or insert
them into plastic slots.
• Seal the hole in the wall through
which the piping is passed so
that no air or water can enter.
Indoor unit test
• Does the ON/OFF switch work properly?
• Do the HEATING, COOLING and FAN modes operate normally?
• Do the TIMER-ON and TIMER-OFF functions operate properly?
• Does each indicator light work properly?
• Do the flaps for air flow direction operate normally?
• Is the condensed water drained regularly?
Outdoor unit test
• Is there any abnormal noise or vibration during operation?
• Could the noise, airflow or condensed water drainage disturb the
neighbours?
• Is there any coolant leakage?
NOTE: The electronic controller allows the compressor to start only three
minutes after voltage has reached the system
20
1300 886 649 (AUS) 0800 836 761 (NZ) |
Piping
Fig. 21
After Sales Support
Insulating
Piping
(Indoor)
.
info@tempo.org
Insulating
Gasket
(Outdoor)
Advertisement
