Using the HP E1364A Form C Switch
Using This Chapter
Form C Switch Commands
Chapter 3
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
This chapter provides examples to use the Form C Switch for switching
channels and scanning channels. As required see Chapter 4, Understanding
the Form C Switch, for further information on scanning channels. See
Chapter 5, Form C Switch Command Reference, for command information.
Chapter contents are:
•
Form C Switch Commands . . . . . . . . . . . . . . . . . . . . . . . . . . Page 25
•
Switching Channels . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 26
•
Scanning Channels . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 31
Table 3-1. Form C Switch Commands in Chapter 3
Command
INIT[:IMM]
OUTP[:STAT] ON
[ROUT:]CLOS < channel_list >
[ROUT:]CLOS? < channel_list >
[ROUT:]OPEN < channel_list >
[ROUT:]SCAN < channel_lis t>
TRIG:SOUR
BUS I EXT I HOLD I IMM
Description
Starts the scan sequence and closes the first
channel in the channel list.
Enables the HP E1300A/E1301A Trig Out port
to output pulses.
Closes the channels in the channel list.
Queries the state of the channels in the
channel list.
Opens the channels in the channel list.
Closes the channels in the channel list, one
channel at a time.
Selects the trigger source to advance the scan.
Using the HP E1364A Form C Switch 25
Chapter 3