Multiple Spectrals (Dmx Control) - SHOWTEC 43532 Manual

Spectral M800 MKII IPX

Multiple Spectrals (DMX Control)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Use a 3-pin XLR cable to connect the Spectrals and other devices.
04) Link the units as shown in fig. 04. Connect a light controller to the first unit's DMX "in" cable, using a
DMX cable. Connect the first unit's "out" 3-pin Neutrik NC3-HD DMX cable with the second unit's "in"
3-pin Neutrik NC3-HD DMX cable. Link the second, third, and fourth units.
05) Supply electric power: Plug electric mains power cords into each unit's special IP65 power IN socket,
then plug the other end of the mains power cord into proper electric power supply sockets, starting
with the first unit. Do not supply power before the whole system is set up and connected properly.
Multiple Spectrals DMX Set Up
Ordercode: 43532
Note : Link all cables before connecting electric power
12
Fig. 04