Installation; Set Up And Operation; Control Modes; One Spectral (Static Colors) - SHOWTEC 43532 Manual

Spectral M800 MKII IPX

Installation

Remove all packing materials from the Spectral M800 MKII IPX. Check if all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.

Control Modes

There are 4 modes:

One Spectral (Static Colors)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the Spectral is not connected with a DMX cable, it functions as a stand-alone device.
Please see page 16 for more information about the static colors.

One Spectral (Built-in programs)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the Spectral is not connected with a DMX cable, it functions as a stand-alone device.
Please see page 17 for more information about the built-in programs.
Ordercode: 43532
• Static Colors (Manual)
• Built-in programs (Auto)
• Master/Slave
• DMX-512 (9CH, 13CH, 3CH, 4CH, 5CH, 3CH)
10