Multiple Spectrals (Master/Slave Control) - SHOWTEC 43532 Manual

Spectral M800 MKII IPX

Multiple Spectrals (Master/Slave control)

01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Use a special 3-pin XLR cable to connect the Spectral.
The pins:
03) Link the units as shown in fig. 03. Connect the first unit's DMX "out" 3-pin Neutrik NC3-HD DMX cable
with the second unit's "in" 3-pin Neutrik NC3-HD DMX cable. Link the second, third, and fourth units.
04) You can use the same functions on the master device as described on pages 16-17 (Static colors
and Built-in programs). This means that you can set your desired operation mode on the master
device and all slave devices will react the same as the master device.
Multiple Spectrals (Master/Slave control)
Ordercode: 43532
01) Earth
02) Signal -
03) Signal +
11
Fig. 03