Settings; Upload; Reset; Color - SHOWTEC 43532 Manual

Spectral M800 MKII IPX

7. Settings

With this menu you can set the device's settings.
01) Press the UP/DOWN buttons until the display shows
02) Press the ENTER button to open the menu.
03) Press the UP/DOWN buttons to toggle between the following menus: Upload, Reset, Color, Dimmer,
Dimming curve, DMX Error, Settings Lock, Strobe Settings, Calibration and Safety Lock.

7.1. Upload

With this menu, you can export current programs from the master device to the connected slave
devices.
01) Press the UP/DOWN buttons until the display shows
02) Press the ENTER button to open the menu.
03) Insert the password: UP>DOWN>UP>DOWN and press the ENTER button to confirm.
04) The display will show
05) Press the ENTER button again, to confirm.
06) While exporting, the slave devices will light up yellow.
07) If there are any problems with exporting, the master and the slave devices will light up red.
08) If the operation was completed successfully, the master and the slave devices will light up green.

7.2. Reset

With this menu, you can reset the custom programs.
01) Press the UP/DOWN buttons until the display shows
02) Press the ENTER button to open the menu.
03) Insert the password: UP>DOWN>UP>DOWN and press the ENTER button to confirm.
04) The display will show

7.3. Color

With this menu, you can adjust the color calibration functions.
01) Press the UP/DOWN buttons until the display shows
02) Press the ENTER button to open the menu.
03) Press the UP/DOWN buttons to toggle between the following 3 options:
04) When the display shows
displayed is the specific color which you have calibrated in
05) When the display shows
and the output is the most powerful.
06) When the display shows
this way, different Spectral versions are color-balanced in order to match each other.

7.4. Dimmer

With this menu, you can adjust the dimmer.
01) Press the UP/DOWN buttons until the display shows
02) Press the ENTER button to open the menu.
03) Press the UP/DOWN buttons to choose one of the 4 dimmer speed options (DIM1-DIM4, from fast to
slow) and OFF.
04) If you choose OFF, then RGBW and the master dimmer are linear.
05) The dimmer settings do not have any influence on the device's performance in DMX TOUR mode.
The DMX settings override the dimmer settings.
Ordercode: 43532
.
and the custom programs will have been reset.
RGB to White
Off
Adjusted output
, RGB to White is active. This means RGB = 255, 255, 255. The color
, the RGB settings are: 255, 255, 255. The RGB values are not adjusted
, the RGB output is adjusted to a standard preset universal color. In
19
.
.
.
.
CAL2 RGBw menu.

.