Table of Contents
Advertisement
Multiple Cameleon Bars
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Use a 3-p XLR cable to connect the Cameleon Bar.
The pins:
3. Link the units as shown in (Fig. 3), Connect a DMX signal cable from the first unit's DMX "out"
socket to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on page 12 (Built-in Programs or
Autorun). This means on the master device you can set your desired operation Mode
and all slave devices will react the same as the master device.
Multiple Cameleon Bars
1.
Plug the end of the electric mains power cord into a proper electric power supply socket.
2. Use a 3-p XLR cable to connect the Messengers.
3. Link the units as shown in (figure 4), Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
4. Supply electric power: Plug the end of the mains power cord into proper electric power supply sockets.
Do so for all units and the controller.
Note : Link all DMX cables before connecting electric power
5. Do not supply power before the whole system is set up and connected properly.
Design your show according to your DMX controller functions. See page 12 for more about DMX
programming.
(Master/Slave control)
1.
Earth
2.
Signal -
3.
Signal +
Multiple Cameleon Bars
(DMX
Control)
Multiple Cameleon Bars Set Up
(Master/Slave control)
9
Fig. 3
Max. 30 Cameleons
Fig. 4
Advertisement
Table of Contents
