Fuse Replacement; Safety Category Ratings - Futech MULTIPOWER 4.6 User Manual

NOTE
To avoid electric shock, remove the test leads
from the meter before removing the battery/
fuse cover.
· Lift up the stand on the back of the device.
· Loosen the screws on the battery/fuse cover.
· Remove battery/fuse cover
· Replace the batteries with four AAA batteries.
· Observe polarity as shown inside battery com-
partment
· Reinstall the battery/fuse cover and tighten the
screws.
NOTE
To avoid electric shock, do not operate the
meter untill the battery/fuse cover is securely
fastened to the meter.

FUSE REPLACEMENT

NOTE
To avoid electric shock, remove the test leads
from the meter before removing the battery/
fuse cover.
14
· Loosen the screws on the batter/fuse cover.
· Remove the battery/fuse cover
· Gently remove fuse and install new fuse into the
holder.
· Always use a UL recognized fuse of the proper
size and value: 800mA/1000V (6.3 x 32mm)
fast blow for the µA/mA ranges and 10A/1000V
(10x38mm) fast blow for the 10A range.
· Reinstall the back cover and tighten the screws.
NOTE
To avoid electric shock, do not operate the
meter untill the battery/fuse cover is securely
fastened to the meter.

SAFETY CATEGORY RATINGS

Per iec1010 overvoltage installation category
Overvoltage category I
Equipment of overvoltage category I is equipment for connection
to circuits in which measures are taken to limit the transient over-
voltages to an appropriate low level.
Note: Examples include protected electronic circuits.
Overvoltage category II
Equipment of overvoltage category II is energy-consuming equip-
ment to be supplied from the fixes installation.
Note: Examples include household, office, and laboratory
appliances.