Table of Contents
Advertisement
Note: If a locking device is available, use it to lock the computer.
3.5–inch storage drive
Prerequisite
Before you start, read Chapter 1 "Important safety information" on page 1 and print the following
instructions.
Attention: The internal storage drive is sensitive. Inappropriate handling might cause damage and
permanent loss of data.
When handling the internal storage drive, observe the following guidelines:
• Replace the internal storage drive only for upgrade or repair. The internal storage drive is not designed for
frequent changes or replacement.
• Before replacing the internal storage drive, make a backup copy of all the data that you want to keep.
• Do not touch the contact edge of the internal storage drive. Otherwise the internal storage drive might get
damaged.
• Do not apply pressure to the internal storage drive.
• Do not make the internal storage drive subject to physical shocks or vibration. Put the internal storage
drive on a soft material, such as cloth, to absorb physical shocks.
Replacement procedure
1. Remove the power cord. See "Power cord" on page 53.
2. Turn off the computer and remove all connected devices and cables.
3. Remove the computer cover. See "Computer cover" on page 54.
4. Remove the front bezel. See "Front bezel" on page 56.
5. Remove the storage drive bay. See "Storage drive bay" on page 61.
6. Remove the screws securing the storage drive to the storage drive bay.
7. Slide the storage drive out of the storage drive bay.
8. Install the new storage drive in the storage drive bay.
.
Chapter 6
Hardware removal and installation
65
Advertisement
Table of Contents
