TOHATSU MFS 8B Owner's Manual page 70

68
INSPECTION AND MAINTENANCE
ENON00028-A
Note
If a torque-wrench is not available when you
are fitting a oil filter, a good estimate of the
correct torque is 3/4 to 1 a turn past finger-
tight. Have the oil filter adjusted to the cor-
rect torque as soon as possible with a
torque-wrench.
7. Reset the engine in a vertical position.
8. Repeat 3 to 7 procedures two or three
times to drain the oil completely.
9. Remove the top cowl and the oil filler
cap.
10. Fill the engine through filler port with
recommended oil (see chart below) to
the middle of dipstick mark.
11. Tighten the oil filler cap.
1
3
10
1. Filler cap
2. Dipstick
3. Filler port
1. Upper limit (Max.)
2. Lower limit (Min.)
ENON00920-0
Note
Use only recommended engine oil (See
page 13)
-30
-22
Oil volume needed for complete oil replace-
With oil filter replace-
2
ENOF01423-0
ENOW00925-0
Wipe off engine oil well immediately if
spilled and dispose of it in accordance with
local fire prevention and environment pro-
tection regulations.
ENON00031-0
Note
1
2
10W−40
10W−30
-20 -10 0 10 20
-4 14 32 50 68
ment
Without oil filter
ment
800 mL(27 fl.oz.)
CAUTION
If any amount of water is found in engine
oil, making it milky white, consult dealer.
ENOF00113-0
30 40 ˚C
86 96 ˚F
ENOF00208-0
replacement