TOHATSU MFS 8B Owner's Manual page 65

ENOM00083-B
Washing outboard motor
ENOW00081-0
WARNING
Do not start engine without removing pro-
peller, or accidentally turning propeller
could cause personal injury.
ENOW00082-0
WARNING
Never start or operate the engine indoors
or in any space which is not well ventilated.
Exhaust gas contains carbon monoxide, a
colorless and odorless gas which can be
fatal if inhaled for any length of time.
ENOW00920-0
CAUTION
When washing the outboard motor, be
careful not to spray the water inside of the
top cowl, especially electrical components.
ENON00026-0
Note
It is recommended to check chemical prop-
erties of water on which your outboard
motor is regularly used.
If outboard motor is used in salt water,
brackish water or water with a high acidic
INSPECTION AND MAINTENANCE
level, use fresh water to remove salt,
chemicals or mud. And flush cooling water
passage after every cruising or before stor-
ing outboard motor for long time. Before
flushing, remove the propeller and the for-
ward thrust holder.
ENOM00085-A
Flushing attachment
ENOW00922-0
ENOF01409-0
To prevent the engine from starting when
you are near the propeller, remove the stop
switch lock.
1. Tilt down the outboard motor.
2. Remove the water plug from the gear
case, and screw in the flushing attach-
ment.
3. Connect a water hose. Turn on the
water and adjust the flow (Be sure to
seal the water inlet, located in the gear
case with tape).
4. Put the shift lever in the neutral position
and start the engine.
Continue flushing the outboard motor
for 3 to 5 minutes at idling.
5. Stop the engine and water supply.
Remove the flushing attachment and
tape. After the flushing, be sure to reat-
tach the water plug.
CAUTION
63
10