1: Mounting The 6855 - Honeywell SILENT KNIGHT 6700 Manual

Control Panel Installation
6855 installation involves the following steps:
1. Ensure power is off at the panel.
2. Mount the 6855 in the desired location (see Section 4.7.1).
3. Connect the 6855 to the panel (see Section 4.6.3).
4. Use the DIP switches on the back of the 6855 to assign an ID#. (See Section Section 4.13.1.)
5. The new 6855 module must be added to the system through programming. JumpStart Auto-Programming will add the module
automatically (see Section 7.1). You can also add it manually (see Section 8.2.2). Select a name, if desired.
4.7.1 Mounting the 6855
This section of the manual describes mounting the remote annunciator. The annunciator can be flush- or surface-mounted.
Flush Mounting
Backbox dimensions are 9-9/32" W x 8-3/8" H. Minimum depth is 2". The backbox can be mounted prior to the complete installation of the
6855 using any of the mounting holes shown below.
6. Remove knockout holes as needed for wires. There are 10 knockouts available, two on each side and two in the back of the cabinet.
7. Wire the annunciator board to the main control panel. Refer to Figure 4.3.
8. Attach the annunciator and door assembly to backbox as shown below using the supplied screws.
32
Model 6855
Figure 4.13 6855 Remote Annunciator
mounting holes
mounting holes
Figure 4.14 6855 Backbox Mounting
6855 Remote Annunciator Installation
6700 Manual — P/N LS10148-001SK-E:F 8/29/2022