Honeywell SILENT KNIGHT 6700 Manual page 97

Panel Operating Modes
Table 9.4 describes the behavior of the panel in each of these modes.
Operating
Occurs When
Mode
Normal No alarm, supervisories
or trouble condition exists
and programming menus
are not in use.
Alarm
A smoke detector goes
into alarm or a pull
station is activated.
CO detector goes into
alarm.
If more than 3 categories
are active at a single
time, the screen will
display as shown.
6700 Manual — P/N LS10148-001SK-E:F 8/29/2022
System Behavior
SYSTEM POWER LED is on. The All Systems Normal
display indicates that the system is in normal mode. The
current date and time display on the last line of the LCD.
Site 1
Model 6700
ALL SYSTEMS NORMAL
08/03/21 01:45:52PM
The communicator seizes control of the phone line and
calls the central station.
The onboard annunciator sounds a loud, steady beep
(any notification devices attached to the system will also
sound).
GENERAL ALARM LED flashes.
The LCD displays a screen similar to this one.
FIRE: ALRM
Waterflow SW
Zone_1
1 of 1
Pressing the right arrow key or Info will display the
location macro, date/time stamp, and site/panel number if
applicable.
Site 1
CO ALRM
[Press for status]
Pressing the down arrow key to view the type and
location of alarm. (Message will alternate with the
date/time display.)
FIRE: ALRM SUPR TRBL
CO: ALRM SUPR
SYS: TRBL
Table 9.4 Panel Operating Modes
Enter the appropriate code or rotate the key to
activate the main menu.
Press the down arrow key to view the alarm. A
screen similar to this one displays.
ALARM: MAN_PULL
MODULE_33 POINT_2
ZONE_2
Press SILENCE and enter an Access Code (or
activate the key) to silence the annunciator (and
Info> any notification devices attached to the system).
When the alarm condition clears, press RESET
and enter a code (or activate the key) to restore the
panel to normal.
System Operation
In This Mode You Can
device
type
3 of 5
showing 3 of 5 events
97