Honeywell SILENT KNIGHT 6700 Manual page 35

5860 Remote Annunciator Installation
The 5860 comes from the factory fully assembled. You must disassemble it for mounting. To disassemble the annunciator, use a 5/64 hex
wrench to remove the set screws, located on the bottom of the annunciator bezel. (See Figure 4.20 for location of the set screws.)
Flush Mounting
This section of the manual describes flush mounting. You can flush-mount with or without an electrical box.

Flush Mounting with an Electrical Box
The 5860 annunciator can be used with the following types of electrical boxes: 4S, single-gang, and double-gang.
If an electrical box is used, the box must be 1-3/8" back from the face of the wall to accommodate the annunciator. Studs used with an elec-
trical box must be 2x4" (or larger).

Flush Mounting Steps
1. Cut a hole in the sheet rock to the following dimensions: 8-1/4" W x 6-5/8"H. If an electrical box is used, the box must be 1-3/8" back
from face of wall to accommodate the annunciator.
2. Remove knockout holes as needed for wires.
3. Fit the annunciator backbox into the hole and stabilize with mounting wires. Angle the mounting wires into the first hole past the sheet
rock. Secure the wires behind the screws as shown in Figure 4.21. When all four wires are in place, the backbox should fit snugly into
the hole in the sheetrock.
4. After the annunciator wiring to the panel has been completed (refer to Figure 4.11), replace the electronic assembly in the back box.
Place the bezel over the back box and tighten the set screws on the bezel.
6700 Manual — P/N LS10148-001SK-E:F 8/29/2022
Figure 4.19 Annunciator Parts
surface mounting holes
holes for inserting wires
for flush-mounting
(located in all corners)
Set Screw
Figure 4.20 Annunciator Backbox and Bezel Details
FIRE ALARM ANNUNCIATOR
screws for placement
knockouts knockouts
Control Panel Installation
of mounting wires
35