Honeywell SILENT KNIGHT 6700 Manual page 84

Programming
• 12 hour
• 6 hour
• 4 hour
NOTE: AM and PM are only available if the panel "Clock Options" are set to AMPM mode. Otherwise, the clock is set in the military time and
you cannot select AMPM.
Phone Lines
To access the Phone Lines screen:
1. Login to the panel.
2. Select 7 to access the Program Menu.
3. From the Program Menu, select 5 to access System Options.
4. Select 1 to access Communication Options.
5. Select 2 to access the Phone Lines menu.
6. Select the phone line to be edited (1 or 2) by pressing the up or down arrow, then press ENTER.
Enter a dialing prefix. Up to 9
characters can be used to allow
for things such as PBX dial-out
codes, a pause, etc.
dial options: touch-tone, pulse, both

Dialing Prefix
Enter up to 9 characters to be used for such things as PBX dial-out codes, a pause, etc. The following special characters are available:
Use the number buttons on the annunciator or the up/down arrow keys to select special characters. Characters begin displaying after "9".
Enter a dialing prefix (if needed), then press ENTER. Or, press the right arrow to bypass the dialing prefix option.

Number of Answer Rings
This option is used in conjunction with the HFSS Honeywell Fire Software Suite. Use the option to determine the number of rings before the
panel answers a call from the computer. The range is 00-15 rings. This option is factory-programmed as 06 rings, which should be compati-
ble for most installations, where the answering machine bypass feature is used. You may need to adjust it depending on the installation's tele-
phone system.
The selections you enter must match the programming for this option in the Communication Configuration dialog box of the HFSS Honey-
well Fire Software Suite.
7. Enter the desired number of answer rings, then press ENTER.

Dial Option (Touch-tone or Pulse)
8. Press the up or down arrow keys to select the Dial Option, then press ENTER.
Dial Option
PULSE If this option is selected, only pulse dialing will be used for this phone line.
TT Touch-tone dialing. If this option is selected, only touch-tone dialing will be used for this phone line.
TT/PL Touch-tone alternating with pulse. If this option is selected, the communicator will first attempt to use touch-tone. It will switch
to pulse if touch-tone is not successful on the first attempt. It will continue to alternate between TT and pulse for additional
attempts.

Dial Format
9. Press the up or down arrow keys to select the pulse ratio to access the Rotary Dialing option, then press ENTER.
The options are as follows:
84
Line:1
phone line to edit
P:
D:TT
<Dialing Prefix>
Figure 8.8 Phone Lines Editing Screen
#
*
,
U U.S. standard format. Uses the 60 msec / 40 msec make/break ratio.
Rings: 06
Options: UNYN
Pound (or number) key on the telephone
Star key on the telephone
Comma (character for 2-second pause)
Description
Table 8.5 Dial Options
6700 Manual — P/N LS10148-001SK-E:F 8/29/2022
N
dial tone detection disabled Y/N
number of rings before the panel
answer a call from a computer
phone line unused Y/N
answering machine bypass Y/N
monitor line Y/N
U for U.S. or E for European
U.S. format = 60/40msec make/break
European = 66/34msec make/break
System Options