Nortel CS 1000M HG Manual page 55

Procedure 4
Setting the S2 dip-switch
Step
1
2
Installing redundant fiber-optic link option
The redundant fiber-optic link is optional. Unless the system configuration
requires a redundant fiber-optic link, it is not necessary to install the
following hardware.
To install the redundant fiber-optic link connectors, install the daughterboard
that corresponds to the type of fiber used in the link. Refer to
"Installing the redundant fiber-optic link option" (page 56)
details.
The daughterboard types are:
•
•
To install the daughterboard, follow the steps in
daughterboard for the fiber-optic link" (page
Procedure 5
Installing the daughterboard for the fiber-optic link
Step
1
2
3
Copyright © 2007, Nortel Networks
.
Action
For the local Fiber Remote Multi-IPE Interface units, set dip-switch
S2 position 1 to OFF.
For the remote Fiber Remote Multi-IPE Interface units, set dip-switch
S2 position 1 to ON, as shown in
Interface configuration" (page
Redundant Option for single-mode fiber
Redundant Option for multi-mode fiber
Action
Remove the two filler plugs on the Fiber Remote Multi-IPE Interface
faceplate labeled XMIT B and RCV B.
Note: The Fiber Remote Multi-IPE Interface mother board has
already been exposed during switch setting procedure.
Locate four screw holes near the top left-hand corner of the
motherboard.
Insert the fiber-optic ST-type connectors into the openings on the
faceplate and install the daughterboard onto the four standoffs.
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 01.01 Standard
Release 5.0 30 May 2007
Fiber-optic equipment installation 55
Table 9 "Fiber Remote Multi-IPE
49).
—End—
Procedure 5 "Installing the
55).
Figure 7
for installation