Installation Overview - Nortel CS 1000M HG Manual

7. Connect the external cables to the I/O panel. Refer to the following:
8. Configure the Remote IPE local and remote sites. Refer to the following:
9. Conduct system acceptance testing. Refer to

Installation overview

The Remote IPE service over a fiber-optic link can be added to an existing
system originally installed and operating without Remote IPE, or it can be
an integral part of a newly installed system.
To install a new system or expand an existing one, refer to Communication
Server 1000M and Meridian 1 Large System Installation and Commissioning
(NN43011-310). It provides the information on how to install, verify, and
maintain Large Systems.
Adding one or more Remote IPE sites to a system is treated as a
straightforward system expansion; that is, the system should be fully
operational before the Remote IPE equipment is installed and connected.
This simplifies installation and fault isolation during installation.
To complete the installation of a Remote IPE site, do the following:
•
•
•
Pre-installation
Pre-installation procedures include:
•
Copyright © 2007, Nortel Networks
.
•
"Setting S1 and S2 switches at the remote site" (page 78)
• "Installing superloop cables" (page 83)
• "Connecting the system monitor cable" (page 84)
• "Connecting the MMI terminal" (page 85)
• "Connecting the fiber-optic link to the Remote IPE Module" (page 87)
•
"Configuring the cards" (page 90)
• "Selecting the MMI terminal modes" (page 94)
• "Configuring the MMI modem" (page 96)
•
"Configuring the Fiber Remote Multi-IPE Interface" (page 98)
testing" (page 105).
perform the preinstallation procedures to prepare the site
install the Fiber Remote Multi-IPE Interface and fiber-optic link
install the copper cables between the Fiber Remote Multi-IPE Interface
units and the local system and between remote Fiber Remote Multi-IPE
Interface units and the Remote IPEs.
preparing the site
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 01.01 Standard
Release 5.0 30 May 2007
Installation overview 41
"Remote IPE acceptance