Nortel CS 1000M HG Manual page 56

56 Installation and configuration
4
5
6
7
Figure 7
Installing the redundant fiber-optic link option
Copyright © 2007, Nortel Networks
.
Tighten the four screws into the standoffs to secure the
daughterboard.
Hand tighten the nuts onto the ST connectors. Do not overtighten.
Plug the ribbon cable from the daughterboard to the connector on
the motherboard.
Close the Fiber Remote Multi-IPE Interface unit by pushing faceplate
in until is flush with the front of the enclosure and no slack is in the
ejector tabs.
Install the Fiber Remote Multi-IPE Interface unit into the
rack-mounted shelf or onto the wall, as shown in
Remote Multi-IPE Interface unit installation methods" (page 59)
Figure 9 "Wall-mounting the Fiber Remote Multi-IPE Interface unit"
(page 61).
Figure 7 "Installing the redundant fiber-optic link option" (page 56)
shows the installation of the daughterboard onto the motherboard
of the Fiber Remote Multi-IPE Interface unit.
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 01.01 Standard
Release 5.0 30 May 2007
—End—
Figure 8 "The Fiber
and