Table of Contents
Advertisement
Machine Operation
Brush Pressure / Load Adjustment
The brush load lever is located to the right hand side of the machine.
This option is for hard to clean patches, adding extra pressure to the brushes.
NOTE: It is recommended this option is NOT used all the time and is for spot cleaning only.
The run-time of the machine may decrease if the load on the brushes is increased.
A
(A) Standard Duty
13 Kg Pressure
Break-away Floor Tool
The floor tool design incorporates a
break-away feature.
Allowing it to safely disengage from its
mounting should it become caught on
an obstruction, during forward machine
movement.
To re-attach the floor tool to its holder. First
loosen the retaining knobs on the floor tool
body and slide onto the holding bracket.
Tighten retaining knobs to finger tight.
!
Machine In Use
To operate, set water flow rate, lower brush deck, lower the floor tool, press the vacuum switch, pull brush On/Off trigger.
Adjust the speed to suit the conditions using the variable speed control,depending on floor type and level of soiling.
Middle speed is the optimum cleaning speed.
The waste water is then retrieved by the suction floor tool.
Overlap each scrubbing path by 10cm to ensure an even clean.
Do not operate the machine on inclines that exceed (6%) when full.
Warning: While on ramps or inclines, avoid sudden stops.Avoid sharp turns. Use low speed down ramps.
Clean only while descending (driving down) the ramp.
On heavily soiled floors use a 'double scrub' technique.
First pre-scrub the floor with the floor tool in the raised position, allow the chemical time to work then scrub the area a second time
with the floor tool lowered.
If streaking occurs wipe floor tool blades clean.
NOTE: Care must be taken to reduce speed when cornering or when manoeuvring around obstacles
B
(B) Heavy Duty
28 Kg Pressure
ALWAYS ENSURE THAT THE FLOOR IS PRE-SWEPT
AND RELEVANT SAFETY SIGNS ARE DISPLAYED.
C
(C) Extra Heavy Duty
50 Kg Pressure
T 01460 68600
!
10
Advertisement
Table of Contents
