Using the machine 2 Speed Control High HI setting LOW setting Cleaning time = 49 mins Cleaning time = 83 mins Charging your battery For information relating to the operation and charging of your battery please refer to the battery and charger original operating instructions Battery Status Fully charged...
Page 5
Tool Tidy NBV Wand Docking PBT 230 607233 Red Caddy 607222 Blue Caddy...
Page 6
Fitting the Face Removing the Face Data Voltage Power Rating Airflow *Run time Size NBV190 340 mm x 340 mm x 340 mm HI = 22.0 L/sec *HI = 49 Mins 36 V (DC) 350 W / 200 W LO = 17.0 L/sec NBV240 360 mm x 370 mm x 415 mm *LO = 83 Mins...
Page 7
Vacuum cleaners that are no longer suitable for use must be separately collected and sent for recovery in an environmentally - friendly manner. Failure to rectify the problem or in the event of a breakdown contact your Numatic dealer or the Numatic Technical helpline +44 (0)1460 269268 Daily Keep the machine clean, including hoses and tubes.
Page 8
Keep diff user fi lter (where fi tted) clean. • Use fi lter bags, they will enhance performance and help keep machine clean. • Use a Numatic Original fi lter bag under fi ne dust conditions. • Keep hoses and tubes clear. •...
Page 9
Optimum Below 20 Limit Below 55 If the battery is found to be faulty at any time, contact Numatic International, or your supplier for information on disposal. Lithium-Ion Battery Warranty Warranty: Commercial Use a. Batteries are warranted (1 Year) providing all battery care rules are followed b.
Page 10
If on checking the battery is found to be operational then a single recharge cycle under observation can be attempted with the appropriate Numatic charger. If the battery recharges correctly on this single recharge cycle then it can be deemed a good battery.
Page 11
The appliance is not intended for use by children or infi rmed persons without supervision. Warning: The battery included in this product must only be charged by the Numatic Charger and docking system supplied with the product and in NO circumstances should an alternative non Numatic charger be...
Page 12
Instructions for Use - Charging Batteries The charger is intended for use only on fl at surfaces, place horizontally on fl oor or work suface. The charger is intended for use with the detachable power cord supplied, the power unit is capable of operating at diff erent voltages without user adjustment.
Page 13
Instructions for Use - Charging Batteries The charger is intended for use only on fl at surfaces, place horizontally on fl oor or work suface. The charger is intended for use with the detachable power cord supplied, the power unit is capable of operating at diff erent voltages without user adjustment.
To claim warranty the following details must be supplied i. Serial number of the machine ii. Battery date code iii. Date purchased iv. Proof of Purchase v. Maintenance history and charging regime Failure to use the correct Numatic charger will void your warranty.
Need help?
Do you have a question about the NBV 190 and is the answer not in the manual?
Questions and answers