XDP Recreation G SURF N SWING'IN Series Manual page 30

- Slide assembly (continued)
STEP 11
 Attach X6 to X1-N and X2-N. The inner sides of both X2-N and X1-N, where X6
(slide ladder steps) is attached to, are with concave holes.
 Secure each side using Z1, Z6 and Z4.
 Attach X3-N to X1-N and X2-N.

Align holes and hold in position.
Narrow side (Direction as
shown below)
Wide side faces the front
direction of the slide
X1-N
Z6
Z1
NOTE:
1. Do not over-tighten the nuts and bolts at every step.
2. Do not snap in the cover of plastic cap until you have finished the assembly of
each step and went back to tighten all of the nuts and bolts.
CONTACT XDP FOR PARTS AND SUPPORT AT 1.866.884.0535 or service@xdprecreation.com
Z4
Z6
X6
Z4
Z6
X3-N
DO NOT RETURN TO RETAILER WHERE YOU PURCHASED AT.
Front
side
X2-N
Z1
Z6
X3-N
29