XDP Recreation G SURF N SWING'IN Series Manual page 19

STEP 4 - "SWING SEAT" assembly (w. "Adjustable Height" Feature)
Important: Please make sure to use the J1 with J3-N (the plastic is Ivory Color).
This is CRITICAL to other assembly steps.
 Connect swing seat to the chains by inserting J3 through K1 and secure with J7,
J9 and J6 as shown in Diagram A.
 Connect swing set chains to the top bar by inserting J3-N through A3, securing
with J8 and J6 as shown in Diagram B.
 If you wish to shorten the chain length, follow Diagram C.
Diagram A
IMPORTANT: The METAL 'washer' (J7) is
NOTE:
1.
Do not over-tighten the nuts and bolts at every step.
2. Do not snap in the cover of plastic cap until you have finished the assembly of
each step and went back to tighten all of the nuts and bolts.
CONTACT XDP FOR PARTS AND SUPPORT AT 1.866.884.0535 or service@xdprecreation.com
J1
J3
J7
J6
needed in the seat assembly.
DO NOT RETURN TO RETAILER WHERE YOU PURCHASED AT.
J1
J3
J7
J9
J9
J6
K1
18