Start Up - Thermo Scientific Precision Water Bath User Manual

Chapter 4
| Operation
CAUTION
4-2
| Precision

Start Up

Before starting, double check all electrical connections.
Do not run the bath until fluid is added to the reservoir. Have extra fluid on hand. If the bath does
not start refer to Chapter 6 Troubleshooting.
Place the circuit protector located on the rear of the bath to the I position.
•
• The screen will momentarily display
the set point and the audible alarm status. The set point is the desired reservoir fluid temperature.
• Press to start the bath and display the reservoir fluid temperature. If the fluid
temperature is below the set point the heater will start.
29.9°C
35.0°C
Note Coliform bath set points are fixed and cannot be changed. The four set points are 35.0°C,
41.5°C, 44.5°C and 45.5°C (95.0°F, 106.7°F, 112.1°F and 113.9°F).
and then the home screen appears displaying
35.0°C
Thermo Scientific